[2023] Use Real Cisco Dumps - 100% Free 350-501 Exam Dumps [Q206-Q223]

[2023] Use Real Cisco Dumps - 100% Free 350-501 Exam Dumps

Realistic 350-501 Dumps Latest Cisco Practice Tests Dumps

NEW QUESTION # 206
A regional MPLS VPN provider operates in two regions and wants to provide MPLS L3VPN service for a customer with two sites in these separate locations. The VPN provider approaches another organization to provide backbone carrier services so that the provider will connect to these two locations.
What is the next step?

A. When edge at different regional sites are connected over the global carrier backbone, MP-eBGP must run between routers to exchange the customer VPNv4 routes.
B. When eBGP is used for label exchange using the send-label option. MPLS-BGP forwarding is configured under the global ABC CSC PE-to-CE interface.
C. When IGP used for route exchange and LDP for label exchange, MPLS is enabled only on the VRF interface on the backbone-carrier PE side.
D. When BGP is used for both route and label exchange, the neighbor a.b.c.d send-label command is used under the address-family VPNv4 command mode.

Answer: A

NEW QUESTION # 207
Refer to the exhibit.

What is the result of this configuration?

A. Router 1 opens and closes a TCP connection to the TACACS+ server every time a user requires authentication.
B. Router 1 and the TACACS+ server maintain one open connection between them.
C. Router 1 and the TACACS+ server maintain one open connection between them only when network administrator is accessing the router with password ciscotest.
D. Router 1 opens and closes a TCP connection to the TACACS+ server every time a user requires authorization.

Answer: B

Explanation:
https://www.ccexpert.us/cisco-secure/configuring-tacacs-on-cisco-ios.html single-connection (Optional) Used to specify a single connection. Rather than have the router open and close a TCP connection to the daemon each time it must communicate, the single-connection option maintains a single open connection between the router and the daemon. This is more efficient because it allows the daemon to handle a higher number of TACACS operations.

NEW QUESTION # 208
A router is configured to perform MPLS LDP graceful restart.
Which three steps are included when the RP sends an LDP initialization to a neighbor to establish an LDP session? (Choose three)

A. Learn from Neighbor (N) flag, set to 1
B. Recovery Time field
C. Reconnect Timeout field
D. Learn from Network (L) flag, set to 1
E. Type-9 LSA
F. Graceful restart capability in OPEN message

Answer: B,C,D

Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_ha/configuration/xe-16-8/mp-ha-xe-16-8- book/nsf-sso-mpls-ldp-and-ldp-graceful-restart.html

NEW QUESTION # 209
Which statement describes the advantage of a Multi Layer control plane?

A. It supports dynamic wavelength restoration in Layer 0
B. It provides multivendor configuration capabilities for Layer 3 to Layer 1
C. It minimizes human error configuring converged networks
D. It automatically provisions monitors, and manages traffic across Layer 0 to Layer 3

Answer: B

NEW QUESTION # 210
Refer to the exhibit:

Which statement describes the effect of this configuration?

A. It creates an ACL named WEB that filters HTTP traffic.
B. It matches HTTP traffic for use in a policy map
C. It applies a service policy to all interfaces remarking HTTP traffic
D. It modifies the default policy map to allow all HTTP traffic through the router

Answer: B

NEW QUESTION # 211
Refer to the exhibit. An Ethernet access provider is configuring routers PE-1 and PE-2 to provide E-Access EVPL service between UNI and ENNI. ENNI service multiplexing is based on 802.1ad tag 150, and service-multiplexed UNI is based on 802.1q tag 10. Which EFP configurations must the provider implement on PE-1 and PE-2 to establish end-to-end connectivity between CE-1 and CE-2?

A. On PE-1:
interface GigabitEthernet2
service instance 100 ethernet
encapsulation dot1ad 150
rewrite ingress tag pop 1 symmetric
On PE-2:
interface GigabitEthernet2
service instance 2 ethernet
encapsulation dot1q 10
rewrite ingress tag pop 1 symmetric
B. On PE-1:
interface GigabitEthernet2
service instance 100 ethernet
encapsulation dot1ad 150 dot1q 10
rewrite ingress tag pop 2 symmetric
On PE-2:
interface GigabitEthernet2
service instance 2 ethernet
encapsulation dot1q 10
C. On PE-1:
interface GigabitEthernet2
service instance 100 ethernet
encapsulation dot1q 150
rewrite ingress tag pop 1 symmetric
On PE-2:
interface GigabitEthernet2
service instance 2 ethernet
encapsulation dot1q 10
D. On PE-1:
interface GigabitEthernet2
service instance 100 ethernet
encapsulation dot1ad 150
rewrite ingress tag pop 1 symmetric
On PE-2:
interface GigabitEthernet2
service instance 2 ethernet
encapsulation dot1q 10

Answer: B

NEW QUESTION # 212
Which additional configuration is required for NetFlow to provide traceback information?

A. Cisco Express Forwarding must be configured for traffic that is egressing from the router to be properly reported.
B. The BGP routing process must be started for any ingress or egress data to be reported when using NetFlow. Version 5.
C. LLDP must be configured or the device will be unable to locate a NetFlow analyzer.
D. A classification ACL must be configured to identify which type of traffic will be analyzed.

Answer: D

Explanation:

NEW QUESTION # 213
Refer to the exhibit:

A network engineer is implementing a BGP routing policy.
Which effect of this configuration is true?

A. All traffic is assigned a local-preference of 30O regardless of its destination
B. If traffic matches acl10, it is allowed and its local-preference is set to 300
C. All traffic that matches acl10 is allowed without any change to its local-preference
D. All traffic that matches acl10 is dropped without any change to its local-preference

Answer: C

NEW QUESTION # 214
Refer to the exhibit.

An engineer is implementing Auto-RP and reviewing the configuration of the PE-A. Which configuration permits Auto-RP messages to be forwarded over this interface?

A. PE-A(config-if)#ip pim sparse-mode
B. PE-A(config-if)#ip igmp version 3
C. PE-A(config-if)#ip pim sparse-dense-mode
D. PE-A(config-if)#no ip pim bsr-border

Answer: C

NEW QUESTION # 215

Refer to the exhibit. An engineer needs to implement this QoS policy on customer's network due to ongoing slow network issues. What will be the effect on the network when the engineer implements this configuration?

A. Traffic that is identified in the ciscopolicy class map will be marked with IP precedence 1 when it enters the pos0/2/0/0 interface
B. Traffic that is identified in the ciscopolicy class map will be remarked from IP precedence 1 to DSCP AF11 when it exits the pos0/2/0/0 interface
C. Traffic that is identified in the ciscotest class map will be marked with IP precedence 1 when it exits the pos0/2/0/0 interface
D. Traffic that is identified in the ciscotest class map will be remarked from IP precedence 1 to DSCP AF11 when it enters the pos0/2/0/0 interface

Answer: C

Explanation:
Section: Networking

NEW QUESTION # 216
Refer to the exhibit.

A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS deployment Assume that the AToM L2VPN service that connects the two CEs is configured correctly on the service provider network Which action causes the solution to fail?

A. The xconnect statement has not been defined
B. OSPF does not work with L2VPN services
C. The routing protocol network types are not compatible
D. A loopback with a /32 IP address has not been used

Answer: C

NEW QUESTION # 217
Refer to the exhibit:

Which statement about this configuration is true"?

A. It requires OSPF to also be running to have optimized Cisco MPLS TE tunnels
B. It requires an explicit Cisco MPLS TE path to be configured for the tunnel to run
C. It is the configuration for the head-end router of a Cisco MPLS TE tunnel with segment routing
D. It requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run

Answer: D

NEW QUESTION # 218
A network engineer Is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements:
- Management protocols must be marked with DSCP AF class 2 w4h low drop probability.
- Monitoring protocols must be marked with DSCP AF class 1 with low
drop probability.
- All remaining traffic must be marked with a DSCP value of 0.
Which configuration must the engineer implement to satisfy the requirements?

Answer: C

Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus1000/sw/4_0/qos/configuration/ guide/nexus1000v_qos/qos_6dscp_val.pdf

NEW QUESTION # 219
Refer to the exhibit.

Refer to the exhibit. A large service provider is migrating device management from Layer 2 VLAN-based to Layer 3 IP-based solution. An engineer must configure the ISIS solution with these requirements:
Network management server IP 172.16.10.1 must be advertised from the core MPLS network to the regional domain.
The external network 202.10.0.0/24 must not establish ISIS peering with the R5 router.
The regional network must prevent sending unnecessary hello packets and flooding the routing tables of the R5 router.
Which two ISIS parameters must be implemented to meet these requirements? (Choose two.)

A. overload bit passive
B. attached bit on ISIS instance
C. advertise-passive-only
D. passive-interface Loopback0
E. LSP lifetime maximum

Answer: B,E

NEW QUESTION # 220
How does Inter-AS Option-A function when two PE routers in different autonomous systems are directly connected?

A. The two routers share VPNv4 routes over a multihop EBGP session and set up an Inter-AS tunnel using one another's label.
B. The two routers establish an MP-EBGP session to share their customers' respective VPNv4 routes.
C. The two routers treat one another as CE routers and advertise unlabeled IPv4 routes through an EBGP session.
D. The two routers share all Inter-AS VPNv4 routes and redistribute routes within an IBGP session to provide end-to-end reach.

Answer: C

NEW QUESTION # 221
Which configuration modifies Local Packet Transport Services hardware policies?
A)

B)

C)

D)