Pass Your HPE Product Certified HPE2-W09 Exam on Jan 06, 2022 with 78 Questions [Q21-Q45]

Share

Pass Your HPE Product Certified HPE2-W09 Exam on Jan 06, 2022 with 78 Questions

HPE2-W09 Free Exam Study Guide! (Updated 78 Questions)


HP HPE2-W09 Exam Syllabus Topics:

TopicDetails
Topic 1
  • Understand how to use NetEdit to simplify ArubaOS-CX device configuration
  • Understand the components of the ArubaOS-CX Switching architecture
Topic 2
  • Describe the benefits of VSX for a data center networking environment and implement VSX
  • Understand, describe and configure Datacenter Bridging (DCB)
Topic 3
  • Describe data center network design principles, including data center deployment models and the impact of various data center technologies on design
Topic 4
  • Understand, describe and configure EVPN to transport VXLAN thru the datacenter
  • Understand, describe and configure VRF
Topic 5
  • Understand, describe and configure Ethernet Ring Protection Switching (ERPS)
  • Understand, describe and configure VXLAN functionality
Topic 6
  • Understand how to use the ArubaOS-CX Network Analytics Engine (NAE) to enhance monitoring and troubleshooting
  • Describe common data center networking requirements

 

NEW QUESTION 21
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: Different virtual MAC must be used for IPv4 and IPv6 Active Gateway.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 22
Does this correctly describe NetEdit's notification capabilities?
Solution: NetEdlt can send an error link to admins through ServlceNow.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 23
Is this how you should position switches in the ArubaOS-CX portfolio tor data center networks?
Solution: Deploy Aruba 83xx switches as core switches for very large three-tier data center networks.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 24
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: The IPv6 and IPv4 overlay networks can be encapsulated with VXLAN and transmitted through the underlay network.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 25
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: omit the device-specific settings from the configuration plan and include them in command scripts instead.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 26
Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISL between Switch-1 and Switch-2. enable Equal Cost Multi Path (ECMP) on both Switch-1 and Switch-2.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 27
Refer to the exhibit.

which shows the topology tot an Ethernet Ring Protection Switching (ERPS) solution.
Is this a valid design for the control and protected VLANs on the VSX fabric 1 switches?
Solution: Ring l, instance 1:
control VLAN: 1000 protected VLANs: 51-135 Ring 1, Instance 2:
control VLAN: 1000 protected VLANs: 136-220 Ring 2, Instance 1: control VLAN: 1001 protected VLANs: 181 -200 Ring 2, Instance 2: control VLAN: 1001 protected VLANs: 201 -220

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 28
The architect designs a spine and leaf network for a single data center that will use multiple leaf switches as Virtual Tunnel End Points (VTEP). The architect needs to select the type of Integrated Routing & Bridging (IRB) for the solution.
Is this statement about the IRB type true?
Solution: Asymmetric IRB requires a third L3 VNI to route packets between ingress and egress VTEPs.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 29
Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: ensures a minimum bandwidth guarantee between two endpoints traffic with various 802.1 p values.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 30
You want to use NetEdit to configure an AtubaOS-CX switch.
Is this a minimum requirement for setting up communications between the switch and NetEdit?
Solution: Make sure that the SSH server is enabled.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 31
Refer to the exhibit.

The company wants AtubaOS-CX switches to provide VXLAN services for several VMs and servers, as shown in the exhibit. Hypervisors will not run VXLAN for this solution. Is this part of a valid configuration to meet the requirements?
Solution: Attach VNIs 5010 and 5020 to interface 1/1/3 on Switch-2.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 32
Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISI between Switch-1 and Swltch-2. enable active forwarding on LAG 100 on both Switch-1 and Switch-2.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 33
You enter this command on an ArubaOS-CX switch:
Switch# show erps status ring 1
Is this what the specified status means?
Solution: The status is Idle, which means that the ring is up and fully connected with the RPL port blocked.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 34
You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.
Is this a rule for the setup?
Solution: You cannot leak multicast routes.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 35
Is this correct positioning of AtubaOS-CX switches in the data center?
Solution: Aruba CX 6300 switches are an appropriate choice for leaf switches in a leaf-spine topology that uses Virtual Extensible LAN (VXLAN) with Ethernet VPN (EVPN).

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 36
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Combine multiple links between two data centers into link aggregations (but not multi-chassis ones).

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 37
Is this correct positioning of AtubaOS-CX switches in the data center?
Solution: Aruba CX 8325 switches are an appropriate choice for leaf switches in a leaf-spine topology that uses Virtual Extensible LAN (VXLAN) with Ethernet VPN (EVPN).

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 38
Refer to the exhibit.
Refer to the exhibit.

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add VRF B as the secondary VRF on VLAN interface 30.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 39
Is this a requirement for implementing Priority Flow Control (PFC) on an ArubaOS-CX switch interface?
Solution: configuring trust of Cos on the interface

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 40
Refer to the exhibits.


Is this how the switch handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.2. but not 192.168.1.3.

  • A. No
  • B. Yes

Answer: B

 

NEW QUESTION 41
Refer to the exhibit.

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add a route with this command: ip route 10.1.20.0/24 vlan20 vrf A

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 42
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching IERPS) solution?
Solution: Implement Virtual Switching Extension (VSX) on pairs of ERPS switches at the same site.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 43
Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)?
Solution: connecting multiple data centers at Layer 2 while minimizing the number of dark fiber connections required

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 44
Refer to the exhibit.

You need to set up an ArubaOS-CX switch to implement Virtual Extensible LAN (VXLAN) WITHOUT Ethernet VPN (EVPN). The exhibit Indicates which servers should be part of the same VXLANs and the desired VNls for the VXLANs. Assume that the network is already configured to permit each ArubaOS-CX switch to reach each other switch's loopback interface.
Is this part of the process for setting up VXLAN to meet the requirements?
Solution: On Switch-1, set 192.168.1.3 as a peer IP address in the VNI 5020 context.

  • A. No
  • B. Yes

Answer: A

 

NEW QUESTION 45
......

HPE2-W09 Dumps for HPE Product Certified Certified Exam Questions & Answer: https://www.testkingpdf.com/HPE2-W09-testking-pdf-torrent.html

Realistic Verified HPE2-W09 exam dumps Q&As - HPE2-W09 Free Update : https://drive.google.com/open?id=1Rt8GIInv2fKOWdeTg4uDOsSnuxAFrpk3