[Jan-2022] Feel Facebook 200-101 Dumps PDF Will likely be The best Option
200-101 exam torrent Facebook study guide
Facebook 200-101 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
NEW QUESTION 35
An analyst calculates data averages (norms) of more than 2,500 brand lift tests in the industry, then compares it to recent campaign results:
* Campaign delivered Ad recall lift +8.3pt (the norm Ad Recall is 9.Opt with a standard deviation of 0.6pt)
* Campaign delivered Message Association +7.1pt (the norm for Message Association is 7.8pt with a standard deviation of 0.8pt)
* Campaign delivered Favorability +6.3pt (the norm for Favorability is 4.Opt with a standard deviation of 1.1pt)
* Campaign delivered Purchase Intent +5.9pt (the norm for Purchase Intent is 5.3pt with a standard deviation of 0.5pt)
Which conclusion should the analyst make based on this data?
- A. Campaign purchase intent is significantly better than the norm above 95% confidence
- B. Campaign message association is significantly worse than the norm above 95% confidence
- C. Campaign ad recall is significantly worse than the norm above 95% confidence
- D. Campaign favorability is significantly better than the norm above 95% confidence
Answer: A
NEW QUESTION 36
Refer to the exhibit.
What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)
- A. Switch1(config)# interface vlan 1 Switch1(config-if)# ip default-gateway 192.168.1.1
- B. Switch1(config)# vlan database Switch1(config-vlan)# vtp domain XYZ Switch1(config-vlan)# vtp server
- C. Switch1(config)# interface fastethernet 0/1 Switch1(config-if)# switchport mode trunk
- D. Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)# interface fastethernet 0/0.1 Router(config-subif)# encapsulation dot1q 10 Router(config-subif)# ip address 192.168.10.1 255.255.255.0 Router(config)# interface fastethernet 0/0.2 Router(config-subif)# encapsulation dot1q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0
- E. Router(config)# interface fastethernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shut down
- F. Router(config)# router eigrp 100 Router(config-router)# network 192.168.10.0 Router(config-router)# network 192.168.20.0
Answer: C,D
NEW QUESTION 37
What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology?
- A. The multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over point-to-point configurations.
- B. It avoids split-horizon issues with distance vector routing protocols.
- C. IP addresses can be conserved if VLSM is not being used for subnetting.
- D. A multipoint interface offers greater security compared to point-to-point subinterface configurations.
Answer: C
Explanation:
You do not have to assign a separate subnet per sub-interface .if you're using a Class A network (10.x.x.x/8), you blow the whole network on a few connections (if you used VLSM, you could use a better mask, limit the addresses used). if you used 10.0.0.0/8, you would not be assigning the entire /8 to a single network. You would select a subnet mask for the network and then, youwould have to use that mask with all subnets of the network. So if you chose a /24 mask, that would mean that you would have to use a /24 mask for even point-to-point links.
NEW QUESTION 38
What is the default administrative distance of OSPF?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
Explanation:
Default Distance Value Table
This table lists the administrative distance default values of the protocols that Cisco supports:
NEW QUESTION 39
A medium-sized travel business executes a digital strategy with a focus on building brand awareness for its new travel package. The advertiser runs a 4-cell Brand Lift test comparing the Engagement objective against other objectives. Assume the following results:
What strategy is most efficient to achieve the KPI?
- A. Traffic objective
- B. Brand Awareness objective
- C. Engagement objective
- D. Reach objective
Answer: D
NEW QUESTION 40
A router receives information about network 192.168.10.0/24 from multiple sources. What will the router consider the most reliable information about the path to that network?
- A. a directly connected interface with an address of 192.168.10.254/24
- B. a static route to network 192.168.10.0/24 with a local serial interface configured as the next hop
- C. an OSPF update for network 192.168.0.0/16
- D. a static route to network 192.168.10.0/24
- E. a default route with a next hop address of 192.168.10.1
- F. a RIP update for network 192.168.10.0/24
Answer: A
Explanation:
What Is Administrative Distance? http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094195.shtml
Select the Best Path Administrative distance is the first criterion that a router uses to determine which routing protocol to use if two protocols provide route information for the same destination. Administrative distance is a measure of the trustworthiness of the source of the routing information. Administrative distance has only local significance, and is not advertised in routing updates. Note: The smaller the administrative distance value, the more reliable the protocol. For example, if a router receives a route to a certain network from both Open Shortest Path First (OSPF) (default administrative distance - 110) and Interior Gateway Routing Protocol (IGRP) (defaultadministrative distance - 100), the router chooses IGRP because IGRP is more reliable. This means the router adds the IGRP version of the route to the routing table.
NEW QUESTION 41
Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.)
Router(config)# router ospf 1
- A. Only one process number can be used on the same router.
- B. Hello packets are sent to each neighbor to determine the processor identifier.
- C. The process number can be any number from 1 to 65,535.
- D. All OSPF routers in an area must have the same process ID.
- E. Different process identifiers can be used to run multiple OSPF processes
Answer: C,E
NEW QUESTION 42
Which protocol is an open standard protocol framework that is commonly used in VPNs, to provide secure end-to-end communications?
- A. L2TP
- B. PPTP
- C. IPsec
- D. RSA
Answer: C
Explanation:
Internet Protocol Security (IPsec) is a technology protocol suite for securing Internet Protocol (IP) communications by authenticating and/or encrypting each IP packet of a communication session. IPsec also includes protocols for establishing mutual authentication between agents at the beginning of the session and negotiation of cryptographic keys to be used during the session.
NEW QUESTION 43
What can cause two OSPF neighbors to be stuck in the EXSTART state?
- A. There is only layer one connectivity between neighbors.
- B. The OSPF interfaces are in a passive state.
- C. The neighbors have different MTU settings.
- D. There is a low bandwidth connection between neighbors.
Answer: C
NEW QUESTION 44
Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)
- A. 802.1Q trunking ports can also be secure ports.
- B. 802.1Q trunks can use 10 Mb/s Ethernet interfaces.
- C. 802.1Q trunks require full-duplex, point-to-point connectivity.
- D. 802.1Q trunks should have native VLANs that are the same at both ends.
- E. 802.1Q native VLAN frames are untagged by default.
Answer: B,D,E
Explanation:
CCNA Self-Study (ICND Exam): Extending Switched Networks with Virtual LANs http://www.ciscopress.com/articles/article.asp?p=102157&seqNum=2
Topic 2, IP Routing Technologies
NEW QUESTION 45
A small retailer wants to measure the impact of its Facebook campaigns on in-store sales. The company operates a store in a local city with most customers within a 10-mile radius.
What measurement solution should it use?
- A. Matched Market Lift
- B. Marketing Mix Modeling
- C. Conversion Lift
- D. Multi-touch attribution
Answer: B
NEW QUESTION 46
Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0? (Choose two.)
- A. Router(config-router)# network 192.168.16.0 0.0.0.255 area 0
- B. Router(config-router)# network 192.168.16.0 0.0.0.255 0
- C. Router(config)# router ospf 0
- D. Router(config)# router ospf area 0
- E. Router(config)# router ospf 1
- F. Router(config-router)# network 192.168.16.0 255.255.255.0 area 0
Answer: A,E
NEW QUESTION 47
What are three reasons that an organization with multiple branch offices and roaming users might implement a Cisco VPN solution instead of point-to-point WAN links? (Choose three.)
- A. increased security
- B. reduced cost
- C. reduced latency
- D. broadband incompatibility
- E. scalability
- F. better throughput
Answer: A,B,E
NEW QUESTION 48
Refer to the exhibit.
What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)
- A. Switch1(config)# interface vlan 1 Switch1(config-if)# ip default-gateway 192.168.1.1
- B. Switch1(config)# vlan database Switch1(config-vlan)# vtp domain XYZ Switch1(config-vlan)# vtp server
- C. Switch1(config)# interface fastethernet 0/1 Switch1(config-if)# switchport mode trunk
- D. Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)# interface fastethernet 0/0.1 Router(config-subif)# encapsulation dot1q 10 Router(config-subif)# ip address 192.168.10.1 255.255.255.0 Router(config)# interface fastethernet 0/0.2 Router(config-subif)# encapsulation dot1q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0
- E. Router(config)# interface fastethernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shut down
- F. Router(config)# router eigrp 100 Router(config-router)# network 192.168.10.0 Router(config-router)# network 192.168.20.0
Answer: C,D
Explanation:
http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008009
49fd.shtml https://learningnetwork.cisco.com/servlet/JiveServlet/download/56692461/Router%20on%20a%20Stick.pdf.
NEW QUESTION 49
Refer to the exhibit.
What address is a feasible successor?
- A. 172.16.4.0
- B. 10.1.4.4
- C. 172.16.3.0
- D. 10.1.2.2
Answer: D
NEW QUESTION 50
What information does a router running a link-state protocol use to build and maintain its topological database? (Choose two.)
- A. routing tables received from other link-state routers
- B. beacons received on point-to-point links
- C. TTL packets from designated routers
- D. hello packets
- E. LSAs from other routers
- F. SAP messages sent by other routers
Answer: D,E
Explanation:
Link State Routing Protocols
http://www.ciscopress.com/articles/article.asp?p=24090&seqNum=4
Link state protocols, sometimes called shortest path first or distributed database protocols, are
built around a well-known algorithm from graph theory, E. W. Dijkstra'a shortest path algorithm.
Examples of link state routing protocols are:
Open Shortest Path First (OSPF) for IP
The ISO's Intermediate System to Intermediate System (IS-IS) for CLNS and IP
DEC's DNA Phase V
Novell's NetWare Link Services Protocol (NLSP)
Although link state protocols are rightly considered more complex than distance vector protocols,
the basic functionality is not complex at all:
1.Each router establishes a relationship-an adjacency-with each of its neighbors.
2.Each router sends link state advertisements (LSAs), some
3.Each router stores a copy of all the LSAs it has seen in a database. If all works well, the databases in all routers should be identical.
4.The completed topological database, also called the link state database, describes a graph of the internetwork. Using the Dijkstra algorithm, each router calculates the shortest path to each network and enters this information into the route table. OSPF Tutorial http://www.9tut.com/ospf-routing-protocol-tutorial
NEW QUESTION 51
......
Use Valid New 200-101 Test Notes & 200-101 Valid Exam Guide: https://www.testkingpdf.com/200-101-testking-pdf-torrent.html
