300-510 Dumps PDF 2024 Strategy Your Preparation Efficiently [Q123-Q139]

Share

300-510 Dumps PDF 2024 Strategy Your Preparation Efficiently

Latest Verified & Correct Cisco 300-510 Questions

NEW QUESTION # 123
Refer to the exhibit. A network engineer is investigating a report of packet drops in an application running on a server connected to PE2. The engineer determined that:
- The OSPF adjacency in area 0 is up, and it is learning the loopback
addresses of all routers in area 0.
- Traffic from users connected to PE1 to the application is also
passing normally.
- Packets from PE2 back to PE1 are being dropped.
Which action resolves the issue?

  • A. RR2(config)# router bgp 100
    RR2(config-router)# no neighbor 10.10.20.1 send-label
  • B. RR1(config)# router bgp 100
    RR1(config-router)# neighbor 10.10.30.1 send-label
  • C. RR1(config)# router bgp 100
    RR1(config-router)# redistribute ospf 100
  • D. RR2(config)# router bgp 100
    RR2(config-router)# redistribute ospf 100

Answer: B


NEW QUESTION # 124
Refer to the exhibit.

Which LSA type is indicated by this router output?

  • A. type 4 LSA
  • B. type 1 LSA
  • C. type 3 LSA
  • D. type 2 LSA

Answer: B


NEW QUESTION # 125

Refer to the exhibit. CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must be able to reach PE1. Which configuration achieves this goal?

  • A.
  • B.
  • C.
  • D.

Answer: C

Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/47868-ospfdb9.html


NEW QUESTION # 126
Refer to the exhibit.

Which tree does multicast traffic follow?

  • A. MDT voice
  • B. MDT default
  • C. source tree
  • D. shared tree

Answer: B


NEW QUESTION # 127
Refer to the exhibit.

Which attribute can router 1 alter so that only other iBGP peers prefer to use 192.168.4.2 as the next hop for route 192.168.3.0/24?

  • A. origin
  • B. MED
  • C. weight
  • D. local preference

Answer: D

Explanation:
Weight is local to the router while LP allows routers in an AS with multiple exit points to choose which exit point is used to reach a particular NLRI.


NEW QUESTION # 128
Refer io the exhibit.

While applying the configurations on two routers an engineer notices that OSPF adjacency Between them remains down Through the ping test the engineer confirmed that both me routers have Layer 3 reachability between them Which action should me engineer take to make the adjacencies to full?

  • A. Delete the area 0 authentication message-digest command from the OSPF process in R1
  • B. Enable OSPF just inside the router OSPF process not in the interfaces of any router
  • C. Enter the command ip ospf authentication in R2 interface
  • D. Delete the area 0 authentication message-digest command from the OSPF process in R2

Answer: C


NEW QUESTION # 129
Refer to the exhibit. Unified MPLS is implemented on this network to provide end-to-end services.
A network engineer noticed that R3 is failing to receive labels from R1. However, R2 is receiving labels from R1. R3 can ping R1 normally. Which action resolves the issue?

  • A. Add the cdp run command to the link configuration between R1 and R3.
  • B. Configure R1 to run Unified MPLS on both interfaces.
  • C. Disable mpls Ip on the link between R1 and R3.
  • D. Add the send-label keyword in the R1 neighbor statement for R3.

Answer: D


NEW QUESTION # 130
Compare different features between OSPFv2 and OSPFv3. Drag and drop the descriptions of OSPF from the left onto the correct OSPF versions on the right.

Answer:

Explanation:


NEW QUESTION # 131
Refer to the exhibit.

Router 1 is connected to router 2 on interface TenGigE0/1. Which interface provides the alternate path to 172.16.200.9/32 when the link between router 1 and router 2 goes down?

  • A. A backup path must be statically installed
  • B. TenGigE0/1 interface provides the alternate path
  • C. TenGigE0/2 interface provides the alternate path
  • D. A primary path must be manually installed

Answer: C


NEW QUESTION # 132
Refer to the exhibit. An engineer is addressing an IS-IS design issue which is running within the topology.
All links are running on FastEthernet, except the link between R5 and R4, which is Gigabit Ethernet.
Which statement about the design is true?

  • A. R4 prefer to reach R5 using R1 as the next hop
  • B. All links have equal cost if the default metric is used
  • C. R1 prefer to use R5 as the next hop to reach R4
  • D. R5 prefers to use R4 as the next hop for all routes

Answer: B


NEW QUESTION # 133
Refer to the exhibit.

Refer to the exhibit. A network engineer is configuring router R3 to handle multicast streams, but Host-2 cannot send subscriptions messages to the IPTV source. Which configuration must the engineer apply to router R3 so it passes the IPTV stream to Host-2?

  • A. Option A
  • B. Option B
  • C. Option C
  • D. Option D

Answer: D


NEW QUESTION # 134
A network engineer is troubleshooting OSPF multiareA. Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?

  • A. DR support for topology management
  • B. routing process enabled by default on all interfaces
  • C. hierarchical CLI
  • D. show ip ospf topology command

Answer: C


NEW QUESTION # 135
Refer to me exhibit. Refer to the exhibit. A network engineer sets up a multihoming eBGP topology where multiple Autonomous Systems connect to ASN 64501. The engineer wants to block all the routes coming from ASN 64502 but allow all the others. For that purpose, the following AS Path prefix list is being used:
(config)#ip as-path access-list 10 deny _64502$
What must be fixed to achieve this result?

  • A. At the end ip as-path access-list 10 permit .* must be included
  • B. The statement must CM modified with ip as path access list 1 deny A64502$
  • C. The statement must be modified with ip as-path access-list 1 deny _64502_
  • D. The AS-PATH filter must be defined inside the route-map mode

Answer: A


NEW QUESTION # 136
Refer to the exhibit.

XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed. Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?

  • A. Option A
  • B. Option B
  • C. Option C
  • D. Option D

Answer: D

Explanation:
Reference:
b_routing_cr41crs/b_routing_cr41crs_chapter_01000.html#wp3850885229


NEW QUESTION # 137
Refer to the exhibit.

Refer to the exhibit Networks 172.16.31.0/24 and 172 16 30.0/24 are advertised in area 34. and network 172.22 10.0/24 is advertised in area 0. A recent security review discovered that users connected to routers R1 and R2 have been making unauthorized access to an application running on network 172 16 31 0/24 An engineer determined that routers R1 and R2 are receiving updates for network 17 16 31 0/24 Which action resolves the issue?

  • A. Apply route filtering on router R4 only.
  • B. Apply route filtering on routers R3 and R4.
  • C. Apply route filtering on router R3 only.
  • D. Apply route filtering on routers RI and R2

Answer: A


NEW QUESTION # 138
Refer to the exhibit.

P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which two actions fix the issue? (Choose two.)

  • A. Change MD5 to HMAC-ESP
  • B. Change MD5 to SHA-1
  • C. Change MD5 to HMAC-SHA1-12
  • D. Change MD5 to HMAC-MD5
  • E. Remove the send and accept lifetime under key 1

Answer: C,D

Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r4-0/security/configuration/guide/ sc40crsbook_chapter5.html


NEW QUESTION # 139
......


Passing the Cisco 300-510 certification exam is a great way for IT professionals to demonstrate their expertise in implementing advanced routing solutions in a service provider network environment. Implementing Cisco Service Provider Advanced Routing Solutions certification can help individuals advance their careers in the IT industry and can open up new job opportunities. In addition, it can help organizations ensure that their IT staff has the necessary knowledge and skills to implement advanced routing solutions in their service provider networks.

 

300-510 PDF Dumps Are Helpful To produce Your Dreams Correct QA's: https://www.testkingpdf.com/300-510-testking-pdf-torrent.html

100% Pass Guaranteed Download CCNP Service Provider Exam PDF Q&A: https://drive.google.com/open?id=1xghLCypuve-mtruSRDEuRKW37cZOFAB8